Example of assembled Shield NCS314 Board. Tubes Shield (NCS314 v2.2) Bare PCB. IN-14 Nixie Tubes 6 pcs. Set of Electronic Parts and Components for Shield (NCS314 v2.2) Board.Set of Screws and Spacers for Shield and Arduino Boards. Principal Electrical Scheme on paper.
BOM List for Shield (NCS314 v2.2) Board. User Manual on a Vintage style paper.
Only BARE PCB and full set of electronics parts. Without Arduino, Columns and Power Supply. Shield NCS314 with soldered IN-14 Nixie Tubes. This listing does NOT contain the Arduino board and power supply. And upload software into your arduino.
Easy to build beautiful clock we offer housing. Easy to customize firmware under Your own needs, thanks to an open platform Arduino. The latest version of the firmware always available on GitHub. No need to download drivers we are use only Genuine USB to serial converters.
Drivers for them pre-installed in all popular OS: Windows, MacOS, Linux. Very high qualty of Printed Circuit Boards. If you have ANY questions. Shiled support 6 IN-14 Nixie tubes [hh:mm:ss]. Temperature display (DS18B20) [Celsius or Fahrenheit].GPS time synchronization (requires a standard GPS receiver, NMEA protocol, 5 volt power supply, not included). Operation via IR remote control (Remote control Sony RM-X151, not included).
No need refresh or update information on the tubes. The maximum possible brightness of the tubes.Date format: DD:MM:YY. Unique RGB LEDs backlight with 16,7 million colors. Very easy to switch LEDS off/on. As alarm sound clock uses standard RTTTL (Nokia format) melodies, so You can easy change it. (included songs: mission impossible, we wish you). Easy updating firmware via USB using Arduino IDE. Power On Self-Test (POST): LEDs test, tubes test, sound test. Integrated High Voltage Power supply: 150 220V. 3 PWM channels for RGB LEDs 8 bit per channel = 24bit = 16,7 million colors. It can be disabled in the menu (see manual). Test points for testing, adjusting and controlling low and high voltage circuits. RTC (Real Time Clock) High precision time chip DS3231 with Backup battery. Acquiring time via external GPS module (only with Arduino Mega). 3 buttons on board to control. Potenciometer to adjust High Voltage. IR reciver TSOP4836 for IR remote controllers (may conflict with Tone library). 8 pcs of RGB SMD LEDs. Places for 2 column with 2 neon dots inside. Separate controls upper and lower dots. Recommended: 12V, 1-2A (center pin positive +). Nixie Tubes Shiled NCS314 PCB size: 200mm x 53.34mm. (7.87 x 1.2 in). IN-14 Arduino Shield NCS314 v2.2 Electrical Scheme. Actual photos of the Shield NCS314 DIY KIT. Arduino Nixie Tubes Clock Shield NCS314 Top View. Arduino Nixie Tubes Clock Shield NCS314 bottom View.
Board dimensions in 2D and 3D. Nixie Tubes Clock Shield for Arduino NCS314. This is example of assembled Shield Board NCS314. The base listing contains only BARE PCB and full set of electronics parts (Arduino, Columns and Power Supply are not included).The item "DIY KIT IN-14 Arduino Shield NCS314 Nixie Clock WITH TUBES FREE SHIPPING" is in sale since Wednesday, September 2, 2020. This item is in the category "Home & Garden\Home Décor\Clocks\Alarm Clocks & Clock Radios". The seller is "gra_and_afch_2" and is located in Dnipropetrovsk. This item can be shipped worldwide.